www.scheppach.com
GB
|
41
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical and
electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially haz-
ardous substances that are often contained in electri-
cal and electronic equipment. By properly disposing
of this product, you are also contributing to the effec-
tive use of natural resources. You can obtain informa-
tion on collection points for waste equipment from your
municipal administration, public waste disposal au-
thority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste dis-
posal company.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
15. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
or recycled.
The equipment and its accessories are made
of various types of material, such as metal and
plastic. Defective components must be disposed of as
special waste. Ask your dealer or your local council.
16. Troubleshooting
Fault Possible causes Action
Blade dissolves after
switching off the engine
To slightly tightened fastening nut Tighten the right hand thread nut
Engine will not start Failure mains fuse Check mains fuse
Defective extension cable Replace extension cord
Connections on motor or switch not in order Repair by electrical specialist
Motor or switch faulty Repair by electrical specialist
Motor will not work, the
fuse is active
Cross section of the extension cable is not
sufcient
See „Electrical connection“
Overload by a blunt saw blade Change saw blade
Fire marks on the cutting
surface
Blunt saw blade Have saw blade sharpened (only by
an authorised sharpening specialist)
or change it
Wrong saw blade Change saw blade
To Next Page
Loading...
Need help?
General
