www.scheppach.com
28
|
GB
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re-
used or recycled. The equipment and its ac-
cessories are made of various types of mate-
rial, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your deal-
er or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the eective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
If you return the motor, always return the com-
plete drive unit with the switch.
15. Special Accessories
Cross cutting jig 7312 0025
Circular cutting device 7319 0710
Bit stop 7319 0710
Grinding belt device 7319 0710
Underframe for tables 7319 0709
Automatic starter, type ALV 2 7910 4010
Type ALV 10 7910 4020
Saw bands
for wood:
12/0.5/2360 mm, 4 teeth/inch 7319 0701
Standard saw band
15/0.5/2360 mm, 4 teeth/inch 7319 0704
Straight upright cuts with longitudinal stop
for wood and synthetic materials:
6/0.5/2360 mm, 6 teeth/inch 7319 0702
Turning works with small radius 25 mm
12/0.5/2360 mm, 6 teeth/inch 7319 0705
Precision cutting works
Different materials:
wood, synthetic materials, metals
3.5/0.5/2360 mm, 14 teeth/inch 7319 0706
Extra-fine cutting works, extremely small radiuses
Non-ferrous metals up to 10 mm
6/0.65/2360 mm, 22 teeth/inch 73190707
straight cuts and turning works
Synthetic materials, non-ferrous metals
6/0.65/2360 mm, 10 teeth/inch 73190703
Synthetic materials, non-ferrous metals above 15
mm
12/0.65/2360 mm, 10 teeth/inch 73190708
straight cuts and large radiuses > 60 mm
To Next Page
Need help?
General