www.scheppach.com
GB
|
29
17. Troubleshooting
Failure Possible cause Solution
Motor does not start • Fastening nut tightened insufficiently
• Extension cable defect
• Connections on the motor or switch
defect
• Motor or switch defect
• Check the mains fuse
• See “Electrical Connection” in the operating
• Have it checked by an electrician Brake does
not bleed
• See “Electrical Connection” in the operating
manual
Motor runs forward or
backwards
• Capacitor defect • Have it exchanged by an electrician
No motor output turns
off automatically
• Overload by dull saw
• Wrong saw blade
• Insert a sharpened saw blade; motor can be
turned on again
• Select saw band according to instructions
Burns on the cutting
surface
• Fastening nut tightened insufficiently
• Wrong saw blade
• Insert a sharpened saw blade
• Select saw band according to instructions
Saw band clamps
when working
• Saw band blunt
• Saw band resinified
• Leadership poorly adjusted
• Replace saw band
• Clean saw band
• Saw band guidance according to instructions
To Next Page
Loading...
Need help?
General