What to do if my Scheppach DP18VARIO Power Tool drill bit binds in workpiece?
If your Scheppach Power Tool drill bit binds in the workpiece, it could be because the workpiece is pinching the drill bit or you're applying excessive feed pressure. Try supporting or clamping the workpiece. It may also be due to improper belt tension, so try adjusting it.
Why is my Scheppach Power Tool making noisy operation?
If your Scheppach Power Tool is operating noisily, it could be due to several factors. Check the belt tension and adjust it if necessary. Also, the spindle may be dry and require testing. Ensure the spindle pulley is not loose by checking the retaining nut and tightening it if needed. Finally, tighten the set screw in the motor pulley if that is loose.
Guidelines for operator's personal safety and attire.
Proper usage, maintenance, and care of the power tool.
Steps to attach the column to the machine foot.
How to use the emergency stop switch for immediate machine shutdown.
How to adjust the machine's rotational speed.
Causes of cable damage and safety warnings.
General| Motor Power | 550 W |
|---|---|
| Number of Speed Settings | Variable |
| Spindle Travel | 80 mm |
| Throat | 180 mm |
| Chuck Capacity | 1 – 16 mm |
To Next Page