www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
25
14. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Fault Possible cause Remedy
The motor doesn’t start.
The upper housing unit is not properly
closed.
Screw in the safety thoroughly
The extension cable is defective. Exchange the extension cable or repair it.
No current is coming out of the outlet. Check the mains fuse.
The switch is defective. Check/change
The motor is defective, the capacitor
is defective
Check/change
Shredder material is obstructing the
blade disc.
Pull the main plug, open the housing and
clean it out.
The motor doesn’t do anything,
the safety default switches on.
The extension cable has an
insufcient cross section
Choose an extension cable with a larger
cross section
The cable between the power system
connection and the shredder is too
long.
Create the shortest possible way between
the power system connection and the
shredder.
The motor is overloaded the
safety default switches on.
The quantity of wet shredded material
is too high.
Select a smaller quantity of shredded
material. Now and then, include dry
shredding material
The blade and output areas are
clogged.
Pull the main fuse, open the housing and
clean it out.
The blade is dull. Resharpen or change
The cable between the power system
connection and the shredder is too
long.
Choose an extension cable with a larger
cross section.
The shredder intake is
diminished, reduced cutting
capacity.
The blade is either dull or worn out. Turn blade, sharpen blade or replace
entirely.
Excessive vibrations/noise
Blade nut/bolt loose Tighten blade nut/bolt
Cutting blade damaged Replace blade
Machine damaged internally Contact Service Agent
To Next Page
Loading...
Need help?
General
