Scheppach Herkules RP1800

Scheppach Herkules RP1800

48 pages

To Next Page

To Next Page

Loading...

Nachdrucke, auch auszugsweise, bedürfen der Genehmigung. Technische Änderungen vorbehalten. Abbildungen beispielhaft!

DE

Rüttelplatte

Originalbedienungsanleitung

08

GB

Vibratory Plates

Translation of original instruction manual

21

FR

Plaque vibrante

Traduction des instructions d’origine

33

Art.Nr.

3904606931

AusgabeNr.

3904605850

Rev.Nr.

15/11/2019

RP1800

Table of Contents

Questions and Answers:

N
npopeAug 4, 2025
How to fix Scheppach Herkules RP1800 Power Tool if engine fails to start?
- M
  Mr. Ryan Hurley Jr.Aug 4, 2025
  If the Scheppach Power Tool engine won't start, there are several potential causes: * The spark plug wire may be disconnected. Ensure it's securely attached to the spark plug. * The fuel tank may be empty or contain stale fuel. Refill it with clean, fresh gasoline. * The throttle control lever might not be in the starting position. Move it to the start position. * The choke may not be in the ON position. Position the throttle at choke for a cold start. * The fuel line could be blocked. Clean the fuel line. * The spark plug might be fouled. Clean, adjust the gap, or replace it. * The engine may be flooded. Wait a few minutes before attempting to restart, and avoid priming it.
W
Wendy KempAug 9, 2025
Why Scheppach Herkules RP1800 Power Tool engine runs erratically?
- B
  bconradAug 9, 2025
  If your Scheppach Power Tool engine is running erratically, consider these possible causes and solutions: * Check the spark plug wire. If it's loose, connect and tighten it. * Ensure the unit isn't running on CHOKE. Move the choke lever to OFF. * The fuel line might be blocked, or the fuel could be stale. Clean the fuel line and refill the tank with clean, fresh gasoline. * The vent could be plugged. Clear the vent. * There might be water or dirt in the fuel system. Drain the fuel tank and refill with fresh fuel. * The air cleaner could be dirty. Clean or replace the air cleaner.
J
Jennifer CooperAug 13, 2025
What to do if Scheppach Power Tool engine overheats?
- S
  Shelby PerryAug 14, 2025
  If the Scheppach Power Tool engine overheats, it could be due to: * A dirty air cleaner. Clean the air cleaner. * Restricted airflow. Remove the housing and clean it.
J
Julia FrancoAug 19, 2025
Why Scheppach Herkules RP1800 engine will not stop when throttle control is positioned at stop?
- H
  Heather GrantSep 12, 2025
  If the Scheppach Power Tool engine won't stop when the throttle control is at the stop position, or if the engine speed doesn't increase properly when adjusting the throttle control, it might be due to debris interfering with the throttle link. Clean any dirt and debris that you find.
G
gilmorejohnAug 25, 2025
What to do if Scheppach Herkules RP1800 compactor is difficult to control when pounding?
- A
  Angel AlvarezAug 25, 2025
  If the Scheppach Power Tool compactor is difficult to control when pounding (machine jumps or lurches forward), it may be because the engine speed is too high on hard ground. Try setting the throttle lever at a lower speed.
K
Kaylee RiveraAug 29, 2025
Why Scheppach Herkules RP1800 Power Tool has no compacting function?
- W
  William KelleyAug 29, 2025
  If your Scheppach Power Tool has no compacting function or the plate compactor does not reach the maximum speed, it may be because the drive belt is too loose and slips on the pulley. In this case, you should adjust or replace the drive belt.

Scheppach Herkules RP1800 Specifications

General

Brand	Scheppach
Model	Herkules RP1800
Category	Power Tool
Language	English

Summary

Introduction and Technical Data

Technical Data

Key specifications including displacement, power, and dimensions.

Noise and Vibration Data

Information on sound power and pressure levels.

Operation and Assembly

Scope of Delivery

List of items included with the compactor.

Construction and Assembly

Steps for assembling the compactor components.

Starting and Stopping the Engine

Procedures for safely starting and stopping the engine.

Compaction Guidance

Advice on soil moisture and slope operation.

Safety Guidelines

General Safety Information

Important safety instructions for machine operation.

Personal Safety Guidelines

Critical safety instructions for the operator.

Fuel Handling Precautions

Safety measures for handling flammable fuel.

Additional Safety Instructions

Specific safety warnings and operational advice.

Slope Operation Safety

Guidelines for safe operation on slopes.

Maintenance and Troubleshooting

Maintenance Overview

General guidelines for maintaining the compactor.

Engine Maintenance

Procedures for oil changes and filter service.

Exciter Oil Change

Steps for draining and refilling exciter oil.

Float Chamber Cleaning

Instructions for cleaning the float chamber.

Troubleshooting

Common issues and their solutions.

Warranty and Compliance

CE Declaration of Conformity

Manufacturer's statement of compliance with EU directives.

Warranty Conditions

Terms and conditions for the manufacturer's warranty.

Related product manuals

Preview: Scheppach HF50

Preview: Scheppach HP800

Scheppach HP800

Scheppach HP1100

Scheppach HP1300

Preview: Scheppach HP800S

Scheppach HP800S

Preview: Scheppach HP1100S

Scheppach HP1100S

Preview: Scheppach HP2500S

Scheppach HP2500S

Scheppach HP2300S

Preview: Scheppach HP1800S

Scheppach HP1800S

Preview: Scheppach HP1300S

Scheppach HP1300S

Preview: Scheppach HP3000S

Scheppach HP3000S

Scheppach HP1900S