www.scheppach.com
GB
|
25
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Water is not being
pumped
Pump not connected Connect the pump.
Pump defective Repair by an authorised service centre.
Line is soiled Clean the line.
Pump and lter incorrectly
positioned in relation to
each other
Read the instructions carefully and carry out the
assembly process correctly.
Water is not getting any
cleaner
Pond is too large Choose a larger model.
UVC lamp defective Replace the UVC lamp.
UVC lamp too weak Adhere to replacement interval.
Filter is soiled Use twist-clean function.
To Next Page
Loading...
Need help?
General
