To Next PageTo Next PageWhat to do if my Scheppach HDA-14 Water Filtration Systems motor does not start?
If the motor of your Scheppach Water Filtration System doesn't start, the issue might be with the mains cable or fuse. Check these components first. If the problem persists, it could be a faulty motor or switch, in which case you should contact an electrician for assistance.
Why is the airflow too weak in my Scheppach HDA-14?
Weak airflow in your Scheppach Water Filtration System could be due to a blocked external or internal filter. Try blowing out or replacing the filter to resolve this issue.
General| Brand | Scheppach |
|---|---|
| Model | HDA-14 |
| Category | Water Filtration Systems |
| Language | English |
Specifies the intended use of the air filter for wood dust only.
Instructions on handling electrical connections, voltage checks, and defective cables.
Guidelines for safe operation, including air intake/outlet clearance and filter insertion.
Ensures adequate clearance around air intake and outlets for optimal circulation.
Confirms the device is fully assembled before commissioning.
Instructions for switching the device on and off using the remote or control panel.
Details how to set automatic shut-off times using the 'TIME' button.
States that electrical connections must comply with VDE and DIN provisions.
Describes causes and dangers of damaged connection cables and the need for inspection.
Instructions for removing, cleaning, and replacing the external and internal filters.
Table listing common faults, possible causes, and recommended remedies.
