www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
31
13. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Fault Possible cause Remedy
The equipment does
not start
• Correct starting procedure not followed
• Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
• Follow the instructions for starting
• Clean the spark plug or replace it with a new
one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
The equipment starts
but does not develop
its full power
• Incorrect choke lever setting
• Soiled air lter
• Incorrect carburetor setting
• Cutting blade blunt
• Set the choke lever on the position
• Clean the air lter
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
The engine does not
run smoothly
• Incorrect electrode gap on the spark plug
• Incorrect carburetor setting
• Clean the spark plug and adjust the electrode
gap, or t a new spark plug
• Contact an authorized customer service outlet
If the temperature of
machines is too high
• Engine is overloaded • Insure the machines have rest at regular time
To Next Page
Loading...
