To Next PageTo Next Page
Need help?Do you have a question about the Schier GB-250 and is the answer not in the manual?
General| Category | Grease Interceptor |
|---|---|
| Grease Capacity | 250 lbs |
| Flow Rate | 50 GPM |
| Material | Polyethylene |
| Inlet/Outlet Connection | 4" |
General guidance for plumbers, local codes, and high temp water requirements.
Requirements for installing interceptors under hydrostatic slabs in concrete vaults.
Guidance for high water tables, full unit support, and piping support.
Using AGSI kit for suspended installations to maintain structural integrity.
Warnings on air testing, odor alerts, and performing water tightness tests.
Setting up outlet diffuser, cleanout plugs, and installing flow control for 200 GPM.
Steps for excavating the pit, preparing the base, connecting piping, and testing.
Adjusting cover height, installing risers, backfilling, and pouring concrete slabs.
Warnings on air gaps, odor, and performing water tightness tests.
Setting up outlet diffuser, cleanout plugs, and installing flow control for 200 GPM.
Connecting piping, installing the AGS1 kit, and testing.
Requirement to use Anchor Kit Model AK1 for installations in high water table areas.
Guidance on piping multiple units in series for lower flow rates and higher storage.
