To Next PageTo Next Page
Need help?Do you have a question about the Schier GB2 and is the answer not in the manual?
General| Brand | Schier |
|---|---|
| Model | GB2 |
| Category | Plumbing Product |
| Language | English |
Follow all instructions and local codes; installation by licensed plumber.
Use tempering valve for water over 140°F to prevent damage and voiding warranty.
Regulate sink drain flow to prevent floor water overflow when installing indoors.
Install in watertight vaults or use anchor kits in high water table areas to prevent damage.
Enclose interceptors in watertight vaults when installed under hydrostatic slabs.
Detailed diagram and list of all components of the GB2 grease interceptor.
Critical warnings and safety steps before beginning on-floor installation.
Steps to cap connections and fill the unit to test for leaks.
Instructions for configuring the outlet diffuser and installing cleanout plugs.
Adjusting the internal flow control plate for desired flow rate (35 or 50 GPM).
Guidance on connecting piping to the interceptor, including vent requirements.
Performing required wet or air tests on the installed piping per local codes.
Essential safety warnings and guidelines specific to buried interceptor installations.
Procedure to ensure the interceptor is watertight before backfilling.
Steps to configure the outlet diffuser and install cleanout plugs for buried units.
Calibrating the flow control based on installation height for buried GB2 units.
Connecting pipes to the interceptor and preparing for burial, including excavation.
Guidelines for proper backfilling with aggregate and concrete pad for finished grade.
