Need help?Do you have a question about the Schiit Lokius and is the answer not in the manual?
Lists all included accessories and components with the Lokius equalizer.
Advice on positioning for hum reduction and connecting the Lokius to your audio system.
Guidance on using EQ controls and gain settings for personalized audio tuning.
Detailed guide to connecting balanced/single-ended inputs/outputs and the power adapter.
How to switch between input types and engage/disengage the equalization circuit.
Explanation of how each of the eight knobs adjusts specific frequency bands.
Identifies the power LED and its role in indicating device status.
Advice on resolving audible hum caused by nearby components.
Clarifies the normal delay before audio output after powering on.
Explains causes of distorted audio and provides solutions.
Clarifies the behavior of bypass mode when the Lokius is powered off.
Confirms that balanced and single-ended inputs/outputs can be used concurrently.
Steps to follow if the Lokius unit fails to turn on.
Outlines the warranty coverage, limitations, and service contact information.
General| Bands | 6 |
|---|---|
| Boost/Cut | +/- 12dB |
| Input | RCA |
| Output | RCA |
| Weight | 2 lbs |
| Frequency Response | 20Hz-20kHz, +/-0.1dB |
| Gain | 0dB |
| Input Impedance | 10k ohms |
| Output Impedance | 75 ohms |
| Frequency Bands | 20Hz, 400Hz, 2kHz, 20kHz |
| Power Supply | 16VAC |
| Dimensions | 9 x 6 inches |
| THD | <0.005%, 20Hz-20kHz |
| Type | Analog Equalizer |
| SNR | >115dB, referenced to 2V RMS |
To Next Page