01/201906
EN Dear Customer, the item must be assembled exactly in accordance with the manufacturer‘s instrucons. Otherwise, possible assembly
errors may pose a safety risk and result in the loss of the guarantee. Please use a so surface for installaon (e.g. a blanket) in order to avoid
scratches. Keep these assembly instrucons and pass on with the unit. These assembly instrucons can also be obtained from our customer service
department as a PDF le.
This piece of furniture is designed exclusively for storing texles and commodity goods in private households.
Before drilling it is essenal to check and take into account the posion of electricity cables and water pipes! In the
case of wall installaon it must be ensured that the unit is not mounted on conducng surfaces and only on solid masonry. The installaon material
supplied is suitable for standard, solid masonry. Before wall installaon please check which installaon material is suitable for your wall and exchange
it if necessary.
Only a qualied electrician may establish the electrical connecon in compliance with naonal regulaons
in force, e.g. DIN-VDE regulaon 0100, part 701, IEC 60364-7-701 or HD 60364-7-701. We do not accept any liability in case of non-observance of the
naonal regulaons. Please note that the item may only be installed in a bathroom outside protecon areas 0 to 2 in accordance with the aforemen-
oned VDE rule. In rooms ed with a bath or shower, the circuit must have a residual current operated device (RCD) with a rated value of not more
than 30 mA.
The LED lamps used have an extremely long service life of over 30,000 hours, which is why there is no provision for
replacing the lamp. In the event of a defect, either the power supply or the luminaire must be replaced. In such cases please contact our service
organisaon. This lighng equipment is not suitable for operaon with a dimmer switch!
The packaging consists of recyclable materials. Please dispose of the packaging in accordance with your valid local regulaons
in an environmentally friendly manner. At the end of its useful life, do not dispose of the product with the household waste.
Ask your communal administraon for possibilies of an environmentally sound
disposal.
Please regularly check and ghten all screwed connecons. Loose connecons may cause a safety risk.
Always use slightly moistened cloths or leather to clean your furniture and mirror cabinets. Make sure that all parts
are wiped dry aer use or cleaning. Avoid abrasive substances or substances containing solvents and do not use microbre cloths. Please note that
some highly concentrated cosmecs can cause damage to the material if they are not wiped o immediately. Remove any surrounding moisture
immediately and avoid allowing condensaon to build up. Because such damage is not covered by the guarantee, we would ask you to follow these
instrucons carefully to ensure that you enjoy your product for many years to come. For care instrucons for the individual materials, please visit our
homepage at:
The following symbols are used in these installaon instrucons:
This signal indicates a medium hazard which, if not averted, may result in death or serious injury.
This signal warns of possible property damage.
This signal gives you useful addional informaon on installaon or use.
Before connecng/installing or switching on the item of furniture, it is essenal to note the symbols shown on the type plates.
Protecon class 1
Protecon class 2
Protecon class 3
Replace any broken glass cover.
The product must not be disposed of via household waste.
The marked components must be removed before the furniture
is disposed of. Please note the disposal instrucons and the
dismantling instrucons on page 28 in this connecon.
To Next Page
Loading...