Need help?Do you have a question about the Schiller Grounds Care BOB-CAT 942311G and is the answer not in the manual?
General| Engine Manufacturer | Kawasaki |
|---|---|
| Engine Model | FX850V |
| Engine Type | V-Twin |
| Engine Displacement | 852 cc |
| Drive Type | Hydrostatic |
| Speed Settings | Variable |
| Cutting Height | 1.5 to 5 inches |
| Cutting Width | 61 in |
| Wheel Size | Front: 13 x 6.5-6 in Rear: 24 x 12-12 in |
Unauthorized modifications may present extreme safety hazards.
Explains signal words like DANGER, WARNING, CAUTION.
Operator preparation and training for safe operation of the machine.
Terrain evaluation and clearing the area for safe mowing.
Checks before operating the machine, guards, fasteners, blades.
General safe operating practices, including loading and turns.
Procedures for starting the engine safely.
Steps to safely stop the engine and blades in various situations.
Safe maneuvering techniques, including turns and slopes.
Specific safety precautions when mowing on slopes.
General safety precautions for maintenance tasks.
Safety precautions when handling mower blades.
Safety precautions for handling fuel and refueling.
Safety precautions when working with the battery.
List of tools needed for assembling the machine.
Instructions for unpacking and initial checks of the unit.
Setting the correct tire pressure for the machine.
Adjusting traction levers for operator comfort.
Final checks before operating, including oil levels and battery cables.
Describes the function and positions of the keyswitch.
Explains how to adjust engine speed using the throttle lever.
How to operate the choke control for starting.
Function of the PTO switch for engaging attachments.
Details on the hour meter and service alerts.
Explains the operation and positions of the fuel tank selector valve.
Operation of the lift lever for the cutter deck.
Controls for forward, reverse, steering, and braking.
How to steer the machine using traction levers.
How to engage and disengage the parking brake.
Instructions for pushing the machine with bypass valves open.
Proper procedures for fueling the machine.
Checks and preparations before starting the engine.
How the interlock system prevents operation without the operator.
Step-by-step guide to starting the engine.
Tips for efficient and safe operation.
Procedures for driving and steering the machine.
How to make turns while moving forward.
How to make turns while moving in reverse.
Steps for operating the cutting deck.
Advice for achieving better cutting results.
Daily checks for safe operation and components.
Checks for the interlock system during start and run.
Checking and tightening hardware.
Maintaining correct tire pressure.
Maintenance and safety for the battery.
Points and schedule for lubricating the machine.
Procedures for checking and changing engine oil.
Intervals for oil and filter changes.
How to inspect and maintain spark plugs.
Inspecting and replacing the fuel filter.
Cleaning and maintaining the air cleaner elements.
Importance of clean cooling system and maintenance.
Table of torque specifications for various components.
Procedures for purging air from the hydrostatic transaxle.
Safety and recommendations for transaxle maintenance.
Steps for changing the transaxle fluid and filter.
Instructions for safely removing mower blades.
Importance and procedure for balancing mower blades.
Guidelines for sharpening mower blades.
How to install mower blades correctly.
Procedure for leveling the mower deck.
How to adjust the cutting height of the deck.
Adjusting deck rollers for flotation and scalping protection.
Instructions for adjusting the parking brake linkage.
Procedure for adjusting the hydrostatic neutral position.
How to adjust the height of the arm rests.
Steps for replacing the cutter deck belt.
Information on belt tensioning.
Steps for replacing the transaxle drive belt.
To Next Page
