8
10 Install the armor plate.
11 Connect the battery cable.
Install four (4) AA batteries into the battery holder. Tuck the
cable behind the tab in the escutcheon
After holder
is installed,
tuck cable
behind tab.
Electrical Ratings (6Vdc, 500mA, 3 W)
Power On Self Test (POST)
The POST is a self-diagnostic test that the lock runs to
verify that the lock is installed correctly. The POST takes
approximately 30 seconds after batteries are installed.
During the POST, a series of audible beeps and LED
ashes will occur. If the POST detects an issue, the test will
conclude with three red ashes of the outside LED. Once
commissioned with the ENGAGE mobile app, any issues
identied during POST can be viewed under the View Activity
menu.
12 Install the battery cover and tighten the screw.
12a Optional: Install security screw and washer.
Remove standard screw and washer and replace with
security screw and washer.
13 Install the inside lever.
*included in box
To Next Page
