Schlage Nexia RP200 User Manual

FOR INDOOR USE ONLY!
DO NOT use with non-resistive loads, such as fluorescent lighting,
CFL bulbs or motors.
To reduce the risk of electric shock, this product has a grounding
type plug that has a third (grounding) pin. This plug will only fit
into a grounding type power outlet. If the plug does not fit into the
outlet, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
Any modification or use other than described may damage the unit
and will void the warranty.
Introduction
The RP200 Home Dimmer Module works with the Nexia Home
Intelligence system as both a light controller and a signal repeater to
help extend the range of the Schlage Bridge.
RP200 Home Dimmer Module
User Guide
Installation
1. Plug the dimmer module into any available outlet.
• The dimmer module can be used to control a lamp.
• The dimmer module repeats the Z-Wave™ signal. In some homes, the
dimmer module must be used to improve communication between the
bridge and the lock. During the online portion of the setup, the system
will determine if it is communicating properly or not. You can move the
dimmer module during online setup if necessary.
• The dimmer module should be installed into any indoor, three-prong,
120 volt A/C outlet.
2. (Optional) Plug a lamp into the Z-Wave™ (two-prong) side of the
dimmer module.
• There are two outlets on the dimmer module. One of the outlets has
only two prongs and is labelled with a Z-Wave™ sticker. A lamp (25
watts minimum and 300 watts maximum) can be controlled by the
system if it is plugged into the Z-Wave™ side of the dimmer module.
• Use only an incandescent light bulb in the lamp that is plugged into
the dimmer module. DO NOT use a CFL (compact fluorescent light
bulb) or any other kind of electric device.
• The other outlet has three prongs and can be used simply as a
pass-through outlet (1500 watts maximum). It is not controlled by the
system, and the system is not affected when it is used.
Max. 300W
Incandescent
Z-Wave™
Side
Pass-through
Side
1
2

Schlage Nexia RP200 Specifications

Power

voltage	120 VAC
frequency	60 Hz

Signal

signal frequency	908.42 MHz

Summary

Introduction to the RP200 Dimmer Module

Safe Indoor Use and Load Restrictions

Warning against non-resistive loads and instructions for proper outlet use to avoid shock.

Dimmer Module Installation Steps

Guides on plugging the module into an outlet and its function as a signal repeater.

Connecting a Lamp to the Z-Wave Outlet

Details on using the Z-Wave side for incandescent lamps up to 300W and the pass-through outlet.

Enrollment and Pairing

Dimmer Module Enrollment Procedure

Step-by-step guide for pairing the dimmer module with the bridge.

Controlling Your Lights

Remote Control via Web and App

Instructions for logging into the Nexia website or using the phone app for control.

Manual Operation and Pass-through Outlet

How to use the module's button for on/off/dimming and the function of the pass-through outlet.

RP200 Dimmer Module Specifications and Safety

Power, Signal, and Software Fuse

Electrical specifications, signal frequency, and software-based power protection.

Over-current Protection and Regulatory Notices

Hardware protection against overloads and compliance information like FCC and IC notices.

Product Certification and Support

Details on UL listing, FCC/IC certifications, and customer service contact information.