Schlage RP200 User Manual

Introduction
The RP200 Light Module works as both a light controller and a signal repeater
to help extend the range of your Z-Wave™ network.
Please go to http://monitoringcontrol.verizon.com and follow the simple steps
provided in the online setup wizard. This will enable you to add your Light
Module to the Home Control Network.
FOR INDOOR USE ONLY!
DO NOT use with non-resistive loads, such as fluorescent lighting, CFL
bulbs or motors.
To reduce the risk of electric shock, this product has a grounding type
plug that has a third (grounding) pin. This plug will only fit into a grounding
type power outlet. If the plug does not fit into the outlet, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
Any modification or use other than described may damage the unit and
will void the warranty.
RP200 Light Module
User Guide
Installation
1. Plug the light module into any available outlet.
• The light module can be used to control a lamp.
• The light module repeats the Z-Wave signal. In some homes, the light
module may be used to improve communication between the gateway
device and other Z-Wave devices.
• The light module should be installed into any indoor, three-prong, 120
volt A/C outlet.
2. (Optional) Plug a lamp into the Z-Wave (two-prong) side of the light
module.
• There are two outlets on the light module. One of the outlets has only
two prongs and is labelled with a Z-Wave™ sticker. A lamp (25 watts
minimum and 300 watts maximum) can be controlled by the system if
it is plugged into the Z-Wave™ side of the light module.
• Use only an incandescent light bulb in the lamp that is plugged into
the light module. DO NOT use a CFL (compact fluorescent light bulb)
or any other kind of electric device.
• The other outlet has three prongs and can be used simply as a
pass-through outlet (1500 watts maximum). It is not controlled by the
system, and the system is not affected when it is used.
Max. 300W
Incandescent
Z-Wave™
Side
Pass-through
Side
1
2

Schlage RP200 Specifications

Power

power	120 VAC, 60 Hz

Signal

signal frequency	908.42 MHz

Summary

Introduction to RP200 Light Module

Module Functionality and Network Range

The RP200 Light Module controls lights and repeats Z-Wave signals to extend network range.

Setup and Online Wizard

Follow online setup wizard at monitoringcontrol.verizon.com to add module to network.

Important Safety Warnings

For indoor use only. Do not use with non-resistive loads like CFLs or motors.

Installation Guide

Plugging Module into Outlet

Plug into an indoor, three-prong, 120-volt AC outlet to control a lamp or repeat Z-Wave signals.

Connecting a Lamp to Z-Wave Side

Connect incandescent lamps (25-300W) to the Z-Wave side for system control.

Using the Pass-Through Outlet

The three-prong outlet acts as a pass-through (1500W max) and is not system controlled.

Manual Operation and Controls

Basic Module Operation

Press button to toggle light on/off; press and hold to dim.

Remote Control Options

Control module remotely via web portal, TV widget, or phone application.

Technical Details and Protection

Device Specifications

Power: 120 VAC, 60 Hz. Signal Frequency: 908.42 MHz.

Software and Hardware Protection

Features a software fuse and internal fuse for over-current protection against overload.

Regulatory Compliance and Certification

FCC Compliance Notice

Complies with FCC limits for Class B digital devices to provide protection against harmful interference.

IC Compliance Notice

Complies with Canadian ICES-003 for Class B digital apparatus.

Product Safety Certification

Certified to comply with applicable FCC RF and EMI emissions, and product safety standards.