Schmalz SCPS Series User Manual

Schmalz SCPS Series

34 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Innovative Vacuum for Automation

EN

Operating instructions

Compact ejector SCPS

30.30.01.00422/05 | 07.2018

Table of Contents

Other manuals for Schmalz SCPS Series

Brief Operating Instructions7 pages

Questions and Answers:

S
Stephanie AlvarezJul 27, 2025
Why is the vacuum level not reached or created slowly in my Schmalz Vacuum Cleaner?
- D
  Daniel MasseyJul 27, 2025
  If the vacuum level is not being reached or the vacuum is created too slowly in your Schmalz Vacuum Cleaner, several factors could be at play. Start by checking for a contaminated press-in screen and replace it if necessary. Also, a dirty silencer can cause this issue, so consider replacing it. Inspect the hose connections for any leakage. Similarly, check the suction pad for leaks. Ensure that the operating pressure is adequate, increasing it while staying within the maximum limits. Finally, verify that the internal diameter of the hose lines is sufficient, referring to the recommended hose diameters.
M
michellegarciaAug 10, 2025
What to do if the payload cannot be held securely by Schmalz Vacuum Cleaner?
- C
  Chelsea WadeAug 11, 2025
  If your Schmalz Vacuum Cleaner isn't securely holding the payload, it could be due to a vacuum level that's too low. If the air-saving function is activated, try increasing the control range. Another reason might be that the suction pad is too small; in that case, you should select a larger suction pad.

Schmalz SCPS Series Specifications

General

Brand	Schmalz
Model	SCPS Series
Category	Industrial Equipment
Language	English

Summary

Safety Instructions

General Safety Instructions

Provides essential safety guidelines for operating the ejector and system.

Intended Use

Installation and Operation

Covers critical points for safe installation, operation, and maintenance procedures.

Product Overview

Vacuum Generation (Picking Up Workpiece)

Blow-off (Depositing Workpiece)

Electrical Connection

Describes the M12 connector for power, inputs, and outputs.

Description of Functions

Operating Modes

Explains the different operating modes: Automatic, Manual, and Parameterization.

Automatic Mode

Details the logic and signals for automatic suction and blow-off control.

Manual Mode Operation

Describes how to manually control suction and blow-off functions.

Parameterization Interface

Shows the interface for setting ejector parameters.

Manual Mode Functions

Explains how to activate, use, and deactivate manual mode for independent control.

Manual Suction Control

Manual Blow-off Control

Exiting Manual Mode

Monitoring System Vacuum

Control Function (Air Saving)

Describes the air-saving function that interrupts vacuum generation at H1.

Blow-off Modes

Signal Output Function

Setting Blow-off Volume Flow

Operation and Settings

Viewing and Setting Parameters

Lists settable parameters like H1, H2 thresholds, and blow-off time.

Operation

Mounting Instructions

Pneumatic Connection Guidelines

Details requirements for compressed air quality, hose selection, and installation.

Recommended Line Cross-Sections

Electrical Connection Details

M12 Connector Pin Assignment

Details the pinout, lead colors, symbols, and functions for the M12 connector.

Start of Operations Cycle

Describes the typical handling cycle steps and output monitoring for vacuum establishment.

Maintenance

General Maintenance Procedures

Troubleshooting Guide

Provides a table of common faults, their causes, and solutions.

Technical Data

Electrical Parameters

Details electrical specifications like voltage, current, and signal levels.

General Parameters

Mechanical Parameters

Dimensional Drawings and Data

Related product manuals

Schmalz FXC-SVK-W