Schroeder America 950R User Manual

Please refer to the Schroeder America website (www.schroederamerica.com)
for information relating to Schroeder America installation and Service
Manuals, Instruction Sheets, Technical Bulletins, Service Bulletins, etc.
NOTICE:
The information contained in this document is subject to change without notice.
SCHROEDER AMERICA MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATERIAL, INCLUDING,
BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. SCHROEDER AMERICA shall not be liable for errors contained herein or for incidental consequential
damages in connection with the nishings, performance, or use of this material.
This document contains proprietary information which is protected by copyright. All right reserved.
© Copyright 2015 by Schroeder America, all rights reserved.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This manual must be read and understood before the installation and operation of this dispenser.
Schroeder America
5620 Business Park • San Antonio, TX 78218
210.662.8200 • Fax: 210.667.2600 • www.schroederamerica.com
Toll-Free 877.404.2488
Rev: 1/17
PN: 805-0006
INSTALLATION INSTRUCTION, PARTS LIST
AND CONFIGURATION GUIDE
FOR THE
RECIRCULATING BAR DISPENSER
(BAR GUN)
Dispenser Model No. 950R
3158001

Schroeder America 950R Specifications

General

Brand	Schroeder America
Model	950R
Category	Dispenser
Language	English

Summary

1. INSTILLATION

Base Plate and Inlet Fitting Installation

Instructions for attaching the base plate and installing inlet fittings.

FCM/MM Module and Holster Connection

Steps for connecting the FCM/MM module and installing the holster assembly.

2. RATIO/BRIX

Adjusting Water Flow Rate

Procedure for adjusting the water flow rate using the bar handle buttons.

Adjusting Syrup Flow and Ratio/Brix

Steps to adjust syrup flow using the flow control assembly and separator nozzle.

3. RECIRCULATION LOOP ADJUSTMENT

Adjusting Recirculation Flow for Cooling

4. BUTTERFLY PLATE REMOVAL/REASSEMBLY

5. STEM O-RING REMOVAL AND REPLACEMENT

Stem O-Ring Replacement Procedure

6. REPLACING PRODUCT TUBING

Product Tubing Disconnection and Replacement

Procedure for disconnecting and replacing product tubing lines.

7. CLEANING AND MAINTENANCE - SANITIZING

Daily Cleaning of Handle and Sheathing

Deep Cleaning Procedures

7. CLEANING AND MAINTENANCE - HOLSTER

8. REATTACHING THE BAR GUN ASSEMBLY

Bar Gun Assembly Reattachment Steps

Procedure for correctly reattaching the bar gun assembly to the FCM module.

9. TROUBLE SHOOTING

Common Dispensing Issue Diagnosis

Guide to diagnose and resolve common dispensing problems.

RECIRCULT BARGUN ADJUSTMENT PROCEDURE

Standard Recircuit Adjustment Settings

Standard settings for flow control and Brix screw adjustments.

HANDLE ASSEMBLY - PARTS LIST

Recirculating Bargun Handle Parts List

MANIFOLD ASSEMBLY - PARTS LIST

Recirculating Bargun Manifold Parts List

FLOW CONTROL MODULE ASSEMBLY - PARTS LIST

Flow Control Module Parts List