SCHUBERTH C3 PRO - Accessories and Spare Parts; Communication Systems; Ordering Original SCHUBERTH Parts

EN
1. COMMUNICATION SYSTEMS
Your C3 PRO is supplied ready for installation of the SCHUBERTH
SRC-System™ as standard. The
C3 PRO is already tted with two integrated
antennas to amplify reception and a Bluetooth
®
connection, to provide you
with the best possible radio reception.
Caution:
The installation of a communication system (including basic headsets)
constitutes a modication to the helmet. For this reason it is necessary
for any communication system and headset intended for installation
into a specic model of helmet to be tested and approved in line with
the ECE-R 22.05 European helmet standard, otherwise the helmet’s
approval and compliance with insurance requirements become invalid on
installation.
Integrated antennas for optimal
radio reception
Plug for connection with the
SRC-System™
Bluetooth
®
antenna
Evidence of approval in line with ECE-R 22.05 in connection with a
specic communication system is only valid if certied by an ocial
regulatory oce of an EU member state. Any other form of information
from these or other institutions (e.g. on the general suitability of
communication systems for use in motorcycle helmets) is of no
relevance and the helmet will lose its approval.
2. ACCESSORIES AND SPARE PARTS
We recommend that you only use original SCHUBERTH accessories and
spare parts for your SCHUBERTH helmet as they are specially adapted to
your helmet model.
Caution:
For safety reasons, all other parts of the helmet should only be replaced
by your specialist dealer.
3. ORDERING ORIGINAL SCHUBERTH PARTS
Please contact your specialist dealer for original SCHUBERTH accessories
and replacements.
H. ACCESSORIES AND SPARE PARTS