Schüco DCS - Page 40

Schücode Commissioning instructions – Schüco DCS Touch Display
42
Dok-Nr.10000432116_01
8.4.4. Screen
In the „Screen“ conguration view, it is possible to set the brightness for the screen on the
DCS Touch Display. The following option is available for this:
● Brightness: Here you can adjust the brightness of the screen on the DCS Touch Display between
„0“ and „100“. Here the value is set to „80“ as standard.
INFORMATION
Display of the value
The set value is displayed only in the web interface and not on the screen of the DCS Touch Display.
Proceed as follows to adjust the screen brightness in the DCS Touch Display:
1. Open the „Screen“ conguration view.
2. Adjust the brightness by means of the „Brightness“ control.
INFORMATION
Applying settings
Settings are applied and saved immediately when adjusting the control.