To Next PageTo Next PageWhy is my Schumacher Electric Battery Charger not charging?
If your Schumacher Electric Battery Charger is on but not charging a connected battery, it might not be in charger mode. Press the START/STOP button for the battery that is connected to the charger to initiate charging.
What to do if Schumacher Electric DSR PROSERIES DSR125 indicator lights are erratic?
If the indicator lights on your Schumacher Electric Battery Charger are behaving erratically, and it's not covered in the manual, it could be due to a button being pressed during plugin. Ensure nothing is touching the control panel, then unplug the unit and plug it back in.
What to do if Schumacher Electric Battery Charger shows BAD BAT?
If the Schumacher Electric Battery Charger's display shows “BAD BAT” and an error code, it means the charger couldn't finish charging the battery and is now in abort mode. To resolve this, press the corresponding START/STOP button to turn off and reset the charger.
General| Model | DSR125 |
|---|---|
| Type | Battery Charger |
| Voltage | 12V |
| Amperage | 25A |
| Cranking Amps | 125A |
| Display | Digital |
| Cable Length | 6 ft |
Covers safe handling, extension cord use, and maintenance precautions for the battery charger.
Warns about explosive gases from lead-acid batteries and outlines essential precautions to prevent ignition.
Details precautions for working near batteries, including protective gear and avoiding sparks or metal objects.
Specifies compatible battery types (6V/12V Lead-Acid, 12V LiFePO4) and restrictions to prevent damage.
Guide for preparing batteries before charging and selecting an optimal charger placement for safety.
Steps for safely connecting and disconnecting DC output clips to the battery, both in and out of a vehicle.
Detailed steps for connecting and disconnecting the charger to a battery outside a vehicle.
Guidelines for connecting to a grounded AC outlet and recommendations for using extension cords.
Instruction to remove cord wraps and uncoil cables prior to using the battery charger.
Step-by-step instructions for securely mounting the charger to a wall using provided brackets.
Explains how to use the display button to select battery percentage, amperage, or voltage.
Guide to selecting battery voltage (6V/12V) and type (STD, AGM, GEL, LITH) for proper charging.
Detailed descriptions of Standard, Deep-Cycle, AGM, Gel, and Lithium Ion (LiFePO4) battery types.
Explains the function of the Start/Stop button and interpretation of charging status LED indicators.
Steps for powering up the charger, selecting settings, and starting the charging process.
Describes charging, completion indicators, and special modes like Aborted Charge and Recovery Mode.
Procedure to test battery state using the charger's built-in voltmeter and display.
Explains how battery state, rating, and size influence the duration of the charging process.
Lists common error codes (F01-F10) with their descriptions, reasons, and solutions.
Addresses issues like the charger not charging, erratic lights, or 'BAD BAT' display with possible causes and solutions.
Provides advice on cleaning clamps and the charger case to ensure longevity and prevent corrosion.
Details the electrical input and output specifications for the battery charger.
Outlines the one-year limited warranty, coverage, exclusions, and claim procedures.
