To Next PageTo Next PageWhat to do if Schumacher Electric SC1360 will not turn on?
If your Schumacher Electric Battery Charger doesn't turn on even when connected correctly, it could be due to a few reasons. First, check the AC outlet for a blown fuse or tripped circuit breaker. Second, inspect the power cord and any extension cords for loose connections. Finally, the battery itself might be defective, so consider having it checked.
What to do if Schumacher Electric SC1360 Battery Charger shows lack of progress in Maintain mode?
If your Schumacher Electric Battery Charger shows no progress after 12 hours in Maintain mode, it might be due to a drain on the battery or the battery itself being faulty. Ensure there are no loads on the battery; if there are, disconnect them. If there are no loads, the battery should be checked or replaced.
What to do if Schumacher Electric SC1360 Battery Charger doesn't charge above 10V/5V after 2 hours?
If, after 2 hours of charging with your Schumacher Electric Battery Charger, the battery voltage remains below 10V (for a 12V battery) or 5V (for a 6V battery), the battery may be defective. Ensure there are no loads on the battery. If any exist, remove them. If there are no loads present, have the battery inspected or replaced.
What to do if Schumacher Electric SC1360 desulfation was unsuccessful?
If the desulfation process with your Schumacher Electric Battery Charger is unsuccessful after 10 hours, the battery may be defective. Consider having the battery checked or replaced.
General| Brand | Schumacher Electric |
|---|---|
| Model | SC1360 |
| Category | Battery Charger |
| Language | English |
Covers essential safety precautions for operating the charger, including handling cords and avoiding damage.
Highlights critical warnings about working near lead-acid batteries and the importance of following instructions.
Provides essential personal safety advice, including protective gear and precautions against sparks and acid.
Outlines critical steps for safely connecting and disconnecting DC output clips to the battery and chassis.
Provides a detailed, step-by-step guide for connecting the charger to a battery installed within a vehicle.
Details the procedure for connecting the charger to a battery that has been removed from the vehicle.
Step-by-step guide for charging a battery while it is installed in the vehicle.
Lists common error codes, their descriptions, and recommended solutions for troubleshooting.
