Schumacher Electric ProSeries PSJ-2212 User Manual (English)

Questions and Answers:

A
Amanda RoachAug 11, 2025
Why won't my Schumacher Electric Remote Starter jump start my car?
- T
  Tony ChavezAug 11, 2025
  Your Schumacher Electric Remote Starter might fail to jump start your car for several reasons. First, ensure the clamps have a solid connection to both the battery and the frame, and that these connection points are clean. Second, the jump starter's battery may not be adequately charged; check its charge status by pressing the Display button. The display will show the percentage of charge. Lastly, the vehicle's battery could be defective, in which case you should have it checked.
Y
youngmarkAug 18, 2025
What to do if my Schumacher Electric ProSeries PSJ-2212 alarm is on?
- A
  Amanda StewartAug 18, 2025
  If the alarm on your Schumacher Electric Remote Starter is activated, it likely indicates that the connections are reversed. To resolve this, disconnect the jump starter and reverse the clamps.
P
Peter MyersAug 27, 2025
Why won't my Schumacher Electric Remote Starter power my 12V device?
- K
  karen02Aug 27, 2025
  There are several reasons why your Schumacher Electric Remote Starter might not power your 12V device. First, verify that the 12V device is turned on. Second, check the battery charge status of the jump starter by pressing the Display button. The display will show the percentage of charge. Finally, the 12V device may draw more than 15A or have a short circuit. If this is the case, disconnect the 12V device, and the internal breaker will automatically reset after a minute or two. Then, try using the 12V device again.
R
Ricardo MelendezSep 3, 2025
How to fix a Schumacher Electric ProSeries PSJ-2212 Remote Starter that won’t hold a charge?
- C
  Cristian IngramSep 3, 2025
  If the battery in your Schumacher Electric Remote Starter won’t hold a charge, it could be defective and unable to accept a charge. The solution is to replace the battery.