Schumacher Electric DSR116 User Manual (English)

Questions and Answers:

C
craigamandaAug 13, 2025
Why won't my Schumacher Electric Remote Starter jump start my car?
- M
  Mike WatsonAug 14, 2025
  If your Schumacher Electric Remote Starter won't jump start your car, several factors could be at play. First, ensure the clamps have a solid connection to both the battery and the frame, and that these connection points are clean. Secondly, the jump starter's battery might not be adequately charged; you can verify this by pressing the Display button on the unit's front to see the charge percentage. Lastly, the car's battery itself could be faulty, in which case it should be checked.
L
Lance PowellAug 17, 2025
What to do if my Schumacher Electric DSR116 alarm is on?
- C
  coopermelissaAug 17, 2025
  If your Schumacher Electric Remote Starter's alarm is sounding, it is likely due to reversed connections. To resolve this, disconnect the jump starter and then reverse the clamps, ensuring they are connected to the correct terminals.
R
Russell KnoxAug 21, 2025
Why won’t my Schumacher Electric Remote Starter power my 12V device?
- J
  Jose DavisAug 21, 2025
  If your Schumacher Electric Remote Starter won’t power your 12V device, there are a few potential reasons: * First, ensure that the 12V device is actually turned on. * Second, the jump starter's battery might not be sufficiently charged (below 10.5V). You can check this by pressing the Display button on the front of the unit. * Finally, the 12V device might be drawing more than 15A or have a short circuit. If this is the case, disconnect the device and allow the internal breaker to reset for a couple of minutes before trying again.
M
Mr. Michael ParrishAug 26, 2025
Why won't my Schumacher Electric DSR116 power my 110V AC device?
- A
  Alex Wilcox DVMAug 26, 2025
  If your Schumacher Electric Remote Starter won't power your 110V AC device, there are several potential causes: 1. The converter might not be turned on, so ensure it is switched on. 2. The 110V AC device itself may not be powered on, so check that it is turned on. 3. The jump starter's battery might not be adequately charged (below 10.5V). Check the charge status using the button on the front. 4. The 110V AC device could be drawing more than 400 watts or have a short circuit. Disconnect the device to allow the converter to reset, then try again. If the issue persists, consider using a smaller device.
A
Annette RobertsAug 28, 2025
Why doesn't the green Power LED light on my Schumacher Electric DSR116?
- C
  Cynthia HooperAug 29, 2025
  If the green Power LED on your Schumacher Electric Remote Starter does not light when the charger is properly connected, there are a couple of things to check: First, the AC outlet itself might be dead, so verify that there isn't an open fuse or a tripped circuit breaker supplying the outlet. Second, there might be a poor electrical connection, so inspect the power cord and any extension cords for loose plugs.
E
Eric SmithSep 5, 2025
Why won’t the battery in my Schumacher Electric Remote Starter hold a charge?
- M
  Mr. Brandon Pratt Jr.Sep 5, 2025
  If the battery in your Schumacher Electric Remote Starter won’t hold a charge, it likely indicates that the battery is bad and unable to accept a charge. In this case, the suggested solution is to replace the battery.
V
Vanessa PetersonSep 9, 2025
What does it mean if the red Bad Battery LED is lit and the yellow/orange Charging Status LED is flashing rapidly on my Schumacher Electric DSR116 Remote Starter?
- A
  Angela SolisSep 9, 2025
  If the red Bad Battery LED is lit and the yellow/orange Charging Status LED is flashing rapidly on your Schumacher Electric Remote Starter, it could mean that the battery voltage is still below 10V after 2 hours of charging, in maintain mode, the output current is more than 1.5A for 12 hours, desulfation was unsuccessful, or the battery may be defective. Make sure there are no loads on the battery. If there are, remove them. If there are none, have the battery checked or replaced.