Sec tion IV
NOR MAL PRO CE DURES
4-1. PREFLIGHT REQUIREMENTS
Have a thorough understanding of operating limitations. (Refer to
Section II.)
Service the helicopter as required. (Refer to Aircraft Handling,
Servicing and Maintenance, Section VII.)
Determine that the helicopter loading is within limits. Refer to
Section II and VI.
Check the helicopter performance data. Refer to Sections V, VI and
VIII.
Determine that a Daily Inspection (in accordance with the Handbook
of Maintenance Instructions (HMI)) has been accomplished within
24 hours prior to the first flight of each day.
Perform a pilot’s preflight inspection prior to each flight.
NOTE
: Re fer to the ap pli ca ble Lycoming Op er a tor’s
and Main te nance Man uals listed in Re lated Pub li ca -
tions and Di rec tives ta ble, Sec tion II, Ba sic HMI for
de tailed re quire ments on daily in spec tion of the en -
gine.
It is the pre rog a tive and re spon si bil ity of the he li cop ter
op er a tor or owner to in crease the ex tent and/or fre -
quency of in spec tion to pro mote safe op er a tion when
un usual lo cal con di tions (en vi ron ment, uti li za tion,
etc.) dic tate.
Normal Procedures
SCHWEIZER
Model 269C Helicopter Pilot's Flight Manual
Reissued: 16 Jan 2019
4-1
This Document contains technical data subject to EAR. See WARNING and classifications on first page.
FAA Approved
CSP Book 1 CSP-C-1.indd 85 8/4/19 12:45 PM
To Next Page
Loading...
