SCHWIND Sirius - Page 7

Short Manual “Calibration” 3.7.01
Calibration
Version 3.7.0 / 2019-06-26 Page 7 of 8
 Perform “curvature calibration”:
 Move the SIRIUS in front of the calibration
sphere R.8 with radius 8.00 mm.
 Align top view image:
The cornea reflex must be
tangential to the red line.
(Image in the superior part
of the window).
 Align Placido image:
The red cross must be in the
center of the placido rings
(image in the inferior part of
the window).
 When both images are in the correct position, press the joystick button.
 When the calibration was successful the
following window appears:
 Click “OK” to confirm the calibration.
 If the calibration was unsuccessful, repeat the
whole calibration procedure.