SCHWING GMBH – Separate Placing Booms SPB 02/2014
15
4.1.3 TOOLS REQUIRED FOR ASSEMBLY
VARIATIONS / COMBINATIONS OF SPANNERS, RATCHETS AND AIR
POWERED TOOLS ARE REQUIRED.
1. NUT / BOLT HEAD SIZES ARE :-
- M27 ALLEN KEY FOR MAST CONSTRUCTION BOLTS.
- 36mm SPANNER OR SOCKET FOR THE NUTS.
- 24mm SPANNER FOR THE NUTS ON THE LADDER HOOPS AND THE
DELIVERY PIPE SUPPORT CLAMPS.
2. 17mm AND 19mm SPANNERS/ SOCKETS FOR THE FIXINGS ON THE
WORKING PLATFORM AND TRAP DOOR ASSEMBLY.
3. HAMMER FOR DRIVING IN / OUT THE CONNECTION PINS ON THE
BOOM TO MAST CONNECTION OR THE BOOM ARM TO TURRET
CONNECTION.
4. HYDRAULIC TORQUE WRENCH TO TORQUE THE CONSTRUCTION
BOLTS HOLDING THE FLANGES OF THE MAST SECTIONS.
5. PAINT BRUSH FOR APPLYING GREASE TO CONNECTION PINS/
POINTS.
6. 55mm SOCKET/ SPANNER FOR NUTS ON HOLDING DOWN BOLTS.
THIS LIST IS FOR USE ONLY AS A GUIDELINE AND IS BASED ON THE
FIXINGS PROVIDED WITH “SCHWING” STANDARD SCOPE OF SUPPLY. IF
OTHER SUPPLIERS OF FIXINGS HAVE BEEN USED SEEK THEIR ADVICE
ASTO TOOL REQUIREMENTS.
To Next Page
Loading...