Need help?Do you have a question about the Schwinn SC Power and is the answer not in the manual?
General| Bike Type | Indoor Cycling Bike |
|---|---|
| Resistance | Magnetic |
| Q-Factor | 168 mm |
| Crank Arm Length | 170 mm |
| Weight Capacity | 350 lbs |
| Display Type | LCD |
| Drive System | Belt |
| Power Measurement | Yes |
| Display Features | RPM, Time, Distance, Calories, Heart Rate |
| Seat | Adjustable |
| Pedals | SPD |
Attach front and rear stabilizers using specific hardware (M10 screws, lock washers, washers).
Insert the seat post into the frame by loosening the height adjustment pop pin.
Connect seat assembly to seat post, then tighten fore/aft adjustment knob to lock.
Insert trapezoidal block into post, slide handlebars, and secure with screw.
Secure threaded collar knob insert and tighten fore/aft adjustment knob.
Attach pedals to crank arms, torquing to 33-37 ft-lbs (45-50 Nm).
Secure stabilizer plate and rear stabilizer using M8 bolts and washers.
Insert trapezoidal block into post, slide handlebars, and secure with screw.
Secure threaded collar knob insert and tighten fore/aft adjustment knob.
Use a 21mm wrench to install the seat post pop pin into the frame.
Loosen the seat post pop pin and slide the seat post into the frame.
Connect seat assembly to seat post and tighten knob to lock.
Attach pedals to crank arms, torquing to 33-37 ft-lbs (45-50 Nm).
Secure stabilizer plate and rear stabilizer using M8 bolts and washers.
Insert trapezoidal block into post, slide handlebars, and secure with screw.
Secure threaded collar knob insert and tighten fore/aft adjustment knob.
Use a 21mm wrench to install the seat post pop pin into the frame.
Loosen the seat post pop pin and slide the seat post into the frame.
Connect seat assembly to seat post and tighten knob to lock.
Attach pedals to crank arms, torquing to 33-37 ft-lbs (45-50 Nm).
Guidance to another manual for further SC Power installation steps.
To Next Page
