Need help?Do you have a question about the SCIEX P/ACE MDQ Plus and is the answer not in the manual?
Procedure for installing the UV or PDA detector module onto the P/ACE MDQ Plus instrument.
Procedure for calibrating the PDA detector after installation or maintenance.
Procedure for installing the LIF detector module into the instrument.
Procedure for installing a new capillary into the cartridge assembly.
Procedure for replacing the deuterium lamp when it reaches its end of life or fails.
Procedure for installing a capillary into the standard cartridge for CE-MS interface.
Procedure for installing a capillary into the EDA-only cartridge for CE-MS interface.
Procedure for conducting a standard system performance test to verify instrument function.
Flow chart and steps to diagnose and resolve common LIF detector performance issues.
General| Category | Capillary Electrophoresis System |
|---|---|
| Manufacturer | SCIEX |
| Wavelength Range (UV/Vis) | 190 - 600 nm |
| Capillary Temperature Control | Yes |
| Temperature Control Range | 15 - 60 °C |
| Voltage | Up to 30 kV |
| Data Acquisition Rate | Up to 100 Hz |
| Power Requirements | 100-240 V, 50/60 Hz |
| Software | 32 Karat Software |
| Detection | UV/Vis |
| Detection Modes | Absorbance |
| Voltage Range | 0 to 30 kV |
| Sample Capacity | Up to 96 samples |
To Next Page
