Scion Instruments
Scion Instruments Natgas C Analyzer +He/H
2
Channel Reference Manual Page: 4
INSTRUMENT SPECIFICATIONS
Every instrument is fully tested; the results of the tests, as well as the
methods used during these tests, are presented as part of this manual (refer
to section 1).
START UP
At initial START-UP as well as after a longer idle period,
follow the instructions below:
• Connect all the gases to the instrument.
• Switch the power on.
• Load the appropriate method.
• Check the flow settings.
• Condition the system as described in this manual.
• Do not make any changes to the methods.
• The system is ready for injections.
For a new system there is no need to do any flow measurement or
flow tuning before power-up. The instrument is tuned and tested in
our Factory in Goes.
To Next Page
Loading...
