SCION xB 2012 - RECEIVER ASSEMBLY RADIO UNIT
Preparation
Page 1 of 7 pages
Issue: A 03/03/2011
Part Number: PT546-00120,
PT546-00121
NOTE: Part number of this accessory may not be
the same as the part number illustrated.
Kit Contents
Item # Quantity Reqd. Description
1 1 Receiver Assembly Radio Unit
2 1 Owner’s Manual
3 1 Hardware Bag
4 1 Conversion Cable: USB
5 1 Conversion Cable : 28Pin
6 1 Conversion Cable : Antenna
Hardware Bag Contents
Item # Quantity Reqd. Description
1 8 Bolt (M5 8)
iPod Cable Contents
Item # Quantity Reqd. Description
Additional Items Required For Installation
Item # Quantity Reqd. Description
Conflicts
None
Recommended Tools
Personal & Vehicle
Protection
Notes
Vehicle protection Blankets
Special Tools Notes
USB Flash Drive Media Must contain MP3 songs
Installation Tools Notes
Panel Clip Removal Tool e.g. Toyota SST P/N:-
00002-06002-01
Wrench Open End, 10mm
Socket 10mm
Screwdriver Phillips, #2
Torque Wrench 4.1 N·m (36 lbf ·in)
Masking Tape (2’’ wide)
Special Chemicals Notes
None
General Applicability
All Scion xB
Recommended Sequence of Application
Item # Accessory
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.
To Next Page
Need help?
General
