Scope Communications UK Ltd
Ref: 40A7PROGMANUAL Page 7 of 11 Issue 1
value is 48.
17) [Remind Alert]
A reminder alert beep can be set within the range 1-60 minutes.
“0” = disabled.
18) Hand Program Password
Four digit password which must be entered by user to access hand
programming mode (Hand Program Tick box must be checked to
enable this feature).
19) [Baud rate]
Over air data transmission speed, must be set to match the system
transmitter (if unsure of this, check with your dealer, stating the
transmitter serial number).
20) [Data Polarity]
Data can be sent from the transmitter in Normal or Inverted mode.
Default is Normal.
21) [Channel Freq]
The operating frequency of the pager in MHz, which must match the
transmitter (if unsure of this, check with your dealer, stating the
transmitter serial number).
22) [Max private No.]
The maximum number of messages which will be stored. Adjustable
within the range of 1-60.
23) [Language]
Preset to English (UK).
To Next Page
Loading...
