scope GEO40A10 - User Manual

Hand programming of the GEO40A10 Alphanumeric pager
If necessary insert a battery. Now, press & hold
the ‘Read’ key to switch the pager on. It will start
to emit a series of beeps & you should, whilst
continuing to hold the ‘Read’ key, now also press
& hold the ‘Selection’ key.
Selection Left Right Read
key key key key
After a few seconds the password menu will be
displayed.
The default password is ‘
0000’. Highlighted
digits will flash and can be changed in turn by
using the ‘Left’ or ‘Right’ keys. Confirm each
correct digit & move on to the next by pressing
the ‘Read’ key.
NOTE: ALL PAGERS ARE SHIPPED WITH
DEFAULT PASSWORD OF '0000'.

Summary

GEO40 A10 Alphanumeric Pager Programming Guide

Initial Power On and Password Entry

Power on the pager by holding the 'Read' key, then enter the default password '0000' to access the password menu.

Address and ID Configuration

Modify pager addresses, enable states, and 7-digit IDs or RICs using navigation keys like 'Read' and 'Selection'.

Frequency and Baud Rate Settings

Adjust radio frequency (Hz) and baud rate (Bits/sec) settings using the 'Selection' and 'Read' keys to confirm.

Saving or Discarding Changes

Confirm or cancel programmed settings by toggling 'YES' or 'NO' and pressing the 'Read' key.

scope GEO40A10 Specifications

General

Brand	scope
Model	GEO40A10
Category	Pager
Language	English