Use and Operation
Once started, the ice machine will automatically
make ice until the bin is full of ice. When ice level
drops, the ice machine will resume making ice.
There are four indicator lights at the front of the
control box that provide information on the
condition of the machine.
Indicator Lights:
•
Power
•
Status
•
Water
•
De-scale & Sanitize
Indicator Lights & Their Meanings
Power Status Water De-Scale & Sanitize
Steady Green Normal Normal – bin full or making ice - -
Blinking Green
Self Test
Failure
Switching on or off - -
Blinking Red -
Diagnostic shutdown or, if making
ice, temperature sensor failure
Lack of
water
-
Yellow - - -
Time to de-scale and
sanitize
Blinking
Yellow
- - - In Cleaning mode
Light off No power Switched off Normal Normal
All Blinking Unit remotely locked out – check with leasing company
If the Water light is on, the machine has sensed a
lack of water. Check the water supply to the
machine. The water could have been shut off or the
water filter cartridges might need to be changed.
If the De-Scale light is on, the machine has
determined that it needs to be cleaned. Contact an
authorized Scotsman service agent and have the
machine cleaned, de-scaled and sanitized.
2007
Page 10
CU1526, CU2026, CU3030
Installation Manual
Note: A Component Indicator Light switches ON to
indicate that the component is operating.
Note: There are two Curtain Switch lights, SW1 and
SW2. These single plate models have one curtain
switch light on all the time, as a curtain switch light
is ON when a curtain is either open or not present.
To Next Page
Loading...
