User Manual for
Touch-Free Ice Maker
Dispensers
models
MDT5N25 and
MDT5N40
TABLE OF CONTENTS
Warranty ..................page 2
Installation .................page 2
Location & Assembly............page 2
Plumbing ..................page 3
Electrical ..................page 3
Final Check List...............page 3
Initial Start Up ...............page 3
Maintenance.................page 4
Failure Analysis...............page 4
WARRANTY:
The warranty conditions are those supplied by the official
distributor for your area. In case of parts, only GENUINE
service parts may be used.
TO INSTALL THE MACHINE
This machine is designed to be placed on a counter or on a
model DMS21 machine stand.
Check sales information for other applications.
INSTALLATION LIMITATIONS:
This ice system is designed to be installed indoors, in a
controlled environment:
Min Max
Air Temperature 10
o
C40
o
C
Water Temperature 5
o
C40
o
C
Water Pressure 1 bar 5 bar
Voltage -5% +10%
(Compared to the nameplate)
Operating the machine outside of the limitations is misuse
and can void any warranty.
Scotsman Ice Systems are designed and manufactured with
the highest regard for safety and performance.
Scotsman reserves the right to make design changes and/or
improvements at any time.
Specifications and design are subject to change without
notice.
LOCATION & ASSEMBLY:
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be installed in a
location where it has enough space around it to be accessible
for service, and minimum of 150 mm be allowed at the
sides for air circulation on air cooled models. A minimum of
150 mm should be allowed at the top for service access. Try
to avoid hot, dirty and crowded locations.
Machine Stand Installations:
Tip the machine stand on its back, using parts of the carton
to protect the exterior finish. Install the legs into the
threaded holes in the bottom of the stand. Turn the leg
levelers all the way in preparation for leveling later. Return
the stand to the upright position.
Counter Top Installations:
Locate the plumbing and electrical supply access holes prior
to placing the unit on the counter top.
2
To Next Page
Loading...
