Why is my Scotsman Ice Maker making noise?
Excessive noise in your Scotsman Ice Maker can stem from a few sources. Check for any rattling tubes or loose panels that may be in contact with each other. An out-of-balance fan blade can also cause significant noise, so consider replacing the fan blade. In some cases, the compressor itself may be the source of the noise, necessitating its replacement.
Why is my Scotsman UN324A-1A producing ice slowly?
If your Scotsman Ice Maker's ice production is slow or low, several factors could be responsible. A dirty air filter can restrict airflow, so clean it. Similarly, a dirty condenser can impede performance; check and clean the condenser. Also, be aware that maximum ice production is achieved at 70°F / 21°C air and 50° / 10°C water temperatures. Finally, check for and remove any obstructions restricting airflow to the unit.
What to do if my Scotsman UN324A-1A Ice Maker cycles off and restarts?
If your Scotsman Ice Maker is cycling off and restarting, the issue might be a loose electrical connection. Inspect the power cord and outlet. If the outlet appears worn, consider replacing it.
What causes a moaning noise when Scotsman UN324A-1A is making ice?
A moaning noise during ice making in your Scotsman Ice Maker often indicates that the water seal is being compressed. This is frequently due to a gear reducer bearing failure, which requires replacing the gear reducer.
What to do if my Scotsman Ice Maker is not making ice?
If your Scotsman Ice Maker isn't producing ice, several factors could be at play. First, ensure the unit isn't in off mode or displaying an error code; check the controller code display and press the ON/OFF button to reset. A 'false bin full' issue might exist due to a poor connection to the photo eye set, consider replacing it if needed. Also, verify that there is power to the unit by checking the power light on the controller, and restore power if it's not illuminated. Other potential causes include a non-operating auger motor (check motor windings and replace if open), a seized gear reducer (replace it), or seized auger bearings (replace bearings and seal). If the auger light is on but there's no power to the auger motor, replace the controller. If the controller displays code 2, make s...
Instructions for connecting water supply and drain lines to the ice machine.
Guidelines for the electrician regarding power supply, grounding, and circuit requirements.
A final checklist before powering on the ice machine for the first time.
Step-by-step guide to remove scale from the ice making system using cleaner.
Detailed procedure for replacing the water seal on the auger and evaporator.
Instructions for replacing the top bearing in the extruder breaker assembly.
Steps for replacing the bottom bearing connected to the gear reducer.
Procedure for replacing the unit's power cord, emphasizing OEM parts.
Steps for removing and installing a new controller board.
General| Type | Undercounter Ice Maker |
|---|---|
| Power Supply | 115V/60Hz/1-ph |
| Refrigerant | R404A |
| Ice Type | Nugget |
| Warranty | 3 years parts and labor on all components |
To Next Page