ENGLISHENGLISH
31 |
TREKKING AND TREKKING-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2017ORIGINAL OPERATING INSTRUCTIONS 2017 | TREKKING AND TREKKING-PEDELEC
| 30
DANGER!
G
During use your SCOTT bike is undergoing stress resulting from the surface
of the road and from the rider’s action. Due to these dynamic loads, the
different parts of your bike react with wear and fatigue. Check your SCOTT
bike regularly, i.e. according to the SCOTT service and maintenance schedule,
for wear marks, scratches, deformations, colour changes and any indication
of cracking. Components which have reached the end of their service life may
break without previous warning. Let your SCOTT dealer maintain and service
your SCOTT bike regularly, i.e. according to the SCOTT service and maintenance
schedule. In cases of doubt it is always best to replace components.
ADDITIONAL INFORMATION “TESTS BEFORE EVERY RIDE” WITH
YOUR SCOTT PEDELEC
1. Are the connections of the rechargeable battery, the control unit or the com-
mand console and the drive (d) correctly plugged?
For more information see the system instructions of your drive manufacturer
on this SCOTT info CD.
2. Is your battery fully charged? Remember to fully recharge the battery after
each longer ride (e.g. less than 50% charged). SCOTT uses modern lithi-
um-ion batteries. These have no memory effect. It does not matter, if your
SCOTT pedelec is left as it is for a short time (e.g. during a break) when less
than 50% charged (e). However, you should not wait until the battery is fully
discharged!
For more information see the system instructions of your drive manufacturer
on this SCOTT info CD.
3. Do the display on the control unit (f) and the cycle computer on the han-
dlebars show all the values? Is there any error message or warning on the
display? Check the values are correct before every ride. Do not set off on
your SCOTT pedelec under any circumstances, if the control element shows a
warning.
For more information see the system instructions of your drive manufacturer
on this SCOTT info CD.
7. If your bike has a kickstand, make sure it is fully raised (a) before you set off.
Risk of falling!
8. Do not forget to take a high quality D- (b) or chain lock with you on your ride.
The only way to effectively protect your SCOTT bike against theft is to lock it
to an immovable object.
9. If you want to ride on public roads, make sure your SCOTT bike is equipped
according to the applicable regulations of your country (c). Riding without
lights and reflectors in dark or dim conditions is very dangerous because
you will be seen too late or not at all by other road users. A set of lights that
corresponds to the regulations is a must on public roads. Turn on the lights as
soon as dusk sets in.
For more information see the chapter “Legal requirements for riding on pub-
lic roads“.
DANGER!
G
Do not use your SCOTT bike, if it fails at one of these points! A defective
SCOTT bike can lead to serious accidents! If you are in doubt or if you have
any questions, contact your SCOTT dealer.
DANGER!
G
Improperly closed fastenings, e.g. quick-releases, can cause parts of your
SCOTT bike to come loose and result in serious accidents!
DANGER!
G
Be aware that the distance you need to stop your pedelec increases, when
you are riding with your hands on bar ends or on multi-position handlebars.
The brake levers are not always within easy reach.
b ca e fd
To Next Page
Loading...
Need help?
General
