16 17
Mark the top end of the stem on the steerer and cut
the steerer 3-4mm below the marking. If you are
unsure about your final bar height, include some
standard 1 1/4” round spacers on top of the stem to
maintain flexibility for height adjustment.
Install the headset expander by sliding it into the steerer under slight tension.
FOIL BUILD UP MANUAL / SCOTT / FOIL / 2016
Tighten the expander to 8-10Nm. Use a torque wrench to ensure that you don’t overtighten the bolt.
To Next Page
Loading...
Need help?
General
