GB-
6
RADIO OPERATION
Listening to the radio
1. When the unit is switched on, press the FUNCTION button to select “Radio”
mode.
2. Press the /BAND button to select FM or MW.
3. Hold down
when the unit is receiving a radio station you would like to listen to. For manual
fine-tuning, you can briefly press these buttons repeatedly to adjust the
frequency step by step.
the or
button and it will search up / down. Release the button
FM Stereo
In FM mode, “(ST)” is displayed when the unit is receiving a station with a strong
signal and stereo sound.
For optimum reception
In FM mode, extend and position the FM antenna to achieve optimum reception.
In MW mode, orientate the unit to achieve optimum reception.
Preset radio stations
You can store up to 10 stations for FM and 10 stations for MW.
1. Use the /
/
buttons to search for a station. Press and hold down the
MEM/CLK button and the station number will flash.
2. Press the buttons to select the desired preset number for the station.
3. Press the MEM/CLK button again to confirm the setting.
4. Repeat above steps (1) to (3) to store other stations.
Listening to a preset station
When listening to the radio, press the
/MEM-UPor REPEAT/M-DN button to
select a preset radio station.
CD OPERATION
Start playback
1. When the unit is switched on, press the FUNCTION button to select “CD”
mode.
2. Open the CD compartment cover and insert a CD or CD-R/RW with the printed
side facing up. Close the CD compartment cover.
3. The unit will read the disc and then display the total number of tracks. Press
the button to start playback from the first track. During playback, the current
track number is displayed.,
Pause playback
Press the button to pause playback and “ ” will flash. Press it again to resume
playback.
Stop playback
Press the button to stop playback. Then press the button to start playback
from the first track.
To Next Page
Loading...
Need help?
General
