OWNER’S MANUAL 2007
ENGLISH
07
06
DEUTSCH
FRANÇAIS
If you want to use a different rear shock model than
the one originally on the bike, please make sure that
the shock will not damage the frame.
Please follow the instruction below:
Please make sure that the rear shock or its accessory
parts do not touch the frame when mounting or sus-
pending.
For doing so remove the coil, install the shock and com-
press the shock completely.
If the shock touches the frame while doing so do not
use this shock in order to avoid damage to frame, swin-
garm or shock.
Please check this issue on all travel adjustment
options.
SET-UP OF OTHER SHOCK
MODELS
After a dismantlement of the rear shock, the front
fixing bolt on the mainframe of the rear shock
should be tightened with a tightening torque of
14 Nm, the rear shock fixing bolt on the swingarm
with 10 Nm.
If this is not done correctly the rear shock can be
damaged.
Shock without spring
6
IMPORTANT
On Nitrous bikes of model year 07 you’ll find 2 different
styles of dropouts
Please check the tightening torques of the screws on
the pictures below.
1. Drop out for 12mm through axle system rear hub:
REPLACEABLE DROPOUTS
7
44in-lbs
5Nm
79in-lbs
9Nm
79in-lbs
9Nm
To Next Page
Loading...
Need help?
General
