Need help?Do you have a question about the SCOTT Promask and is the answer not in the manual?
General| Lens Material | Polycarbonate |
|---|---|
| Type | Full Face Mask |
| Facepiece Material | Silicone |
| Standards | EN 136:1998 |
| Threaded Connector | RD40 x 1/7" |
Overview of Promask usage, filter selection, and material.
Overview of Promask² usage, filter selection, and material.
Specific limitations and considerations when using Promask with a blower device.
Guidance on selecting appropriate filters for Promask and Promask² based on hazard types.
Information on selecting and integrating blower devices with Promask systems.
Essential checks to perform on the mask and components before each use.
Specific instructions for donning the mask when used with a blower device.
Step-by-step guide for fitting filters to Promask and Promask² models.
Methods for checking the mask's seal and leak-tightness.
Procedures for testing mask functionality and ensuring leak-tightness.
Instructions for replacing the visor, including material code identification.
Detailed steps for replacing the exhalation valve disc.
Instructions for removing and replacing inhalation valve discs and seats.
Guide for removing and installing the speech diaphragm.
Steps for replacing the harness buckle and reassembling.
Procedure for removing and installing the inner mask.
Guidelines for cleaning the mask components using appropriate cleaning agents.
Steps for disinfecting the inside and face seal of the mask.
Recommended conditions for storing the mask and components.
Guidelines for the proper disposal of contaminated masks and used filters.
Schedule for cleaning, disinfection, and functional testing of mask components.
To Next Page
