17
ENGLISH / SPARK TECH MANUAL
Sag:
1. Make sure before any adjustment is made that your shock and forks are in the
open position. To do this press the twinloc upper silver lever twice.
2. With the shock pump attached to the rear shock valve, pump your desired
pressure into the shock. Once the pressure
is achieved, remove the pump. Then slowly
compress and decompress your shock
through 20% of its travel 10 times. This
will equalize the positive and negative air
chambers, if needed add or reduce pressure
and repeat.
3. Once your desired pressure is reached sit on your bike in your usual riding
position (in your riding gear: if you carry a bag/Hydration-system put it on,) don’t
“bounce” the suspension while doing this, use a wall or a friend for support if
needed. Do not sit on your bike with the shock pump attached to the bike.
4. Use the markings indicated in the linkage and front triangle to check your sag
position. Adjust the pressure as required for your personal sag setting.
5. Recommended Sag is 20% - 25%
01 02
03
To Next Page
Loading...
Need help?
General
