Scotts LCS31440S User Manual

TROUBLESHOOTING
Possible Cause
- Battery not making contact
- Lock off button not fully operated
- Battery not installed properly
- Battery not charged
Possible Solution
-Check battery is fully inserted
-Check that lock off button is fully forward prior to
moving trigger
-Check battery installation
-Check battery charging requirements
- Bar and chain running hot
and smoking
- Check tension for over-tight
condition
- Chain oil tank empty
- Chain installed backwards
- Adjust chain tension
- Fill tank with chain oil
- Reverse chain so that cutters face the right
direction
Call us first with questions about operating or maintaining your product
at 1.800.618.7474 between 8:00 a.m. – 5:00 p.m. Eastern Standard Time,
or get assistance on scotts.americanlawnmower.com.
CALL US FIRST !!
- Chain tension too tight
- Check guide bar and chain for
damage
- Motor runs but chain is not
rotating
-
A
djust chain tension
- Replace damaged bar and chain with identical
replacement parts.
Problem
- Unit does not run
- Motor stops while switch
trigger is depressed
- Motor is overloaded
- Release switch trigger, wait several seconds,
then depress trigger again.Motor should restart.
If it doesn’t, remove battery pack, reinstall
battery pack, then try again.
14
Model LCS31440S

Scotts LCS31440S Specifications

General

Brand	Scotts
Model	LCS31440S
Category	Chainsaw
Language	English