Assembly - 1
ASSEMBLY
Checking Tire Pressure
1. Check tires for damage.
2. Check tire pressure with an accurate gauge.
3. Add or remove air, if necessary:
c
CAUTION: Avoid injury! Explosive separation
of a tire and rim parts can cause serious injury
or death:
- Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
- Always maintain the correct tire pressure. Do
not inflate the tires above the recommended
pressure. Never weld or heat a wheel and tire
assembly. The heat can cause an increase in
air pressure resulting in a tire explosion.
Welding can structurally weaken or deform the
wheel.
- When inflating tires, use a clip-on chuck and
extension hose long enough to allow you to
stand to one side and NOT in front of or over
the tire assembly.
- Check tires for low pressure, cuts, bubbles,
damaged rims or missing lug bolts and nuts.
Tire Size Pressure-kPa (psi)
Front: 15-Inch 97 kPa (14 psi)
Rear: 20-Inch 69 kPa (10 psi)
To Next Page
Loading...
Need help?
General
