PAGE 11
2. CHAIN BRAKE
WARNING
The chain brake is a device which stops the chain
instantaneously if the chain saw recoils due to kickback.
Normally, the brake is activated automatically by inertial force.
It can also be activated manually by pushing the brake lever
(left-hand guard) down toward the front. When the brake
operates, a yellow cone pops up from the base of the brake
lever.
RELEASING THE BRAKE
Pull the brake lever up toward the left-hand handle until it
clicks into place.
• When the brake operates, release the throttle lever to slow
down the engine speed. Continuous operation with the brake
engaged will may overheat the clutch.
• Upon chainsaw inspection prior to each job, check the
operating condition of the brake following these steps:
1. Start the engine and grasp the handle securely with both
hands.
2. Pulling the throttle lever to maintain the chain operation,
push the brake lever (left-hand guard) down toward the
front using the back of your left hand.
3. When the brake operates and the
chain is stopped, release the
throttle lever.
4. Release the brake.
To Next Page
Loading...