PAGE 27
8. STARTING THE ENGINE
= = = = = = = = = = = = = = = = ==
Switch
Throttle
interlock
Throttle
lever
3. Set the switch to “I” position.
4. Pull out the choke to the second-stage position.
The choke will close and the throttle lever will then be set into
the starting position.
When the engine is cool.
When the engine is warmed up.
After the engine starts.
When restarting immediately after stopping the engine,
set the Choke in the first-stage position (choke open and
throttle lever in the starting position). Once the choke has
been pulled out, it will not return to the operating position
even if you press down on it with your finger. When you wish
to return the choke knob to the operating position, pull out
the throttle lever instead.
ZZ
NOTE
To Next Page
Loading...