PAGE 29
8. CHECKING CHAINSAW OIL LEVEL
Make sure to set up the bar and the chain
when checking the oil supply. If not, the
rotating parts may be exposed. This is very
dangerous.
1. After starting the
engine, run the chainsaw at
medium speed and see if
chain oil is scattered off as
shown in the figure.
2. The chain oil flow can be
changed by inserting a
screwdriver in the hole on
bottom of the clutch side.
Adjust according to your
work conditions.
The oil tank should become nearly empty by the time fuel is
used up. Be sure to refill the oil tank every time when refu-
eling the saw.
WARNING
ZZ
NOTE
To Next Page
Loading...