3. Installation
The smaller ICOM transceivers (e.g. IC-706) often use a 13 pin DIN plug for ACC:
Signal PTC Color ICOM 13 pin
GND PIN 2 white PIN 2
PTT PIN 3 yellow PIN 3
AF-OUT PIN 1 violet PIN 11
AF-IN PIN 4 green PIN 12
POWER PIN 5 blue PIN 8
This cable is available completely assembled.
Refer to chapter 5 on page 52.
Table 4: ICOM 13 pin
3.5.2 Connection PTC – Kenwood
Most Kenwood transceivers that use 13 pin DIN plug (ACC2) can be connected this way:
Signal PTC Color Kenwood
GND PIN 2 white PIN 4, 8, 12
PTT PIN 3 yellow PIN 9
AF-OUT PIN 1 violet PIN 11
AF-IN PIN 4 green PIN 3
This cable is available completely assembled.
Refer to chapter 5 on page 52.
Table 5: KENWOOD
The TS-50 can only be connected via the microphone jack:
Signal PTC Color Kenwood
GND PIN 2 white PIN 7, 8
PTT PIN 3 yellow PIN 2
AF-OUT PIN 1 violet PIN 1
AF-IN PIN 4 green PIN 6
Table 6: KENWOOD TS-50
The TS-480 has a 6 pin Mini-DIN connector:
Signal PTC Color YAESU
GND PIN 2 white PIN 2
PTT PIN 3 yellow PIN 3
AF-OUT PIN 1 violet PIN 1
AF-IN PIN 4 green PIN 5
This cable is available completely assembled.
Refer to chapter 5 on page 52.
Table 7: KENWOOD 6 pin Mini-DIN
40
To Next Page
Loading...
