Need help?Do you have a question about the SCS Pactor and is the answer not in the manual?
Contains the foreword, important safety notices, and legal disclaimers for the manual.
Details the equipment's compliance with Federal Communications Commission rules.
Introduces the original PACTOR modem and its development history.
Lists included hardware/software and prerequisites for operating the modem.
Explains the scope and content of the installation manual.
Covers HF email setup and software included on the SCS CD-ROM.
Details Professional Firmware features like PACTOR-III, PACTOR-IP-Bridge, and EasyTransfer.
Provides contact details for SCS, website, and support resources.
Outlines the procedure for sending products for repair and basic troubleshooting tips.
Details how to connect and power the PACTOR modem unit.
Guides on connecting the PTC via its serial port for communication.
Instructions for connecting the PTC via USB and installing necessary drivers.
Explains how to connect and configure the PTC-IInet via Ethernet.
Connects PTC to transceivers via audio. Covers ICOM, Kenwood, Yaesu, and amplitude adjustment.
Instructions for remote control setup with Kenwood, ICOM, and Yaesu transceivers.
Information on installing and using the optional Packet-Radio DSP Module.
Instructions for connecting a GPS receiver to the PTC for data input.
Explains the function of LEDs on PTC-IIex, PTC-IIusb, and PTC-IInet models.
Details the meaning of LEDs and the alphanumeric display on the PTC-IIpro.
Describes how LED indicators show PACTOR-III speed levels and frequency error.
Lists various cables for connecting PTC to transceivers and for extending connections.
Details optional modules like Packet-Radio DSP and specific transceiver control cables.
Provides common technical data for the PACTOR series, including processor and memory.
Details technical specifications for the PTC-IIusb and PTC-IInet models.
Details technical specifications for the PTC-IIpro and PTC-IIex models.
To Next Page
General